Festive season is a fun time until you realize that some lights are out and need to be replaced. The LightKeeper Pro Holiday and Christmas Tree Light Repair Tool keeps the holiday cheer going and saves you money at the same time by letting you quickly fix your existing lights! This bundle from Lifestyle by Focus includes the LightKeeper Pro Holiday and Christmas Tree Light Repair Tool and one hundred Spare Bulbs for allowing you to have complete fun time with your whole family during the festive season. Say good bye to cold trips to the store on festive evenings.

LightKeeper Pro Holiday and Christmas Tree Light Repair Tool

Just use LightKeeper Pro to quickly extract the bulb and replace it with a new one. The Light Repair Tool features a voltage detector to find other causes of light failures such as twisted or cut wires. In case an entire strand of light is out, you can connect the AC plug to the LightKeeper Pro and fix multiple shunts. Additionally, the built-in Bulb Tester tests the repaired and existing bulbs to make sure they work properly before climbing that ladder! The secret compartment in the handle stores spare bulbs and button batteries.

How LightKeeper Pro Works

Most miniature Holiday Light set failures occurs when an individual bulb shunt fails to energize. These shunts are energized when a filament burns out. This causes a section of lights to go out instead of just one light bulb. This is because miniature light sets are wired in series and the electricity must flow through each bulb, to the next, for them to light. The LightKeeper Pro Quick Fix Trigger sends a shaped, electrical pulse through the defective bulb, clearing the shunt. This forces the problem shunt to activate and allows the electricity flow again like it should. The current can then flow through the light set completing the circuit and illuminating the other bulbs. With your problem light strand plugged in, remove an unlit bulb and plug the strand's socket into the LightKeeper Pro. Now pull the trigger up to 20 times (usually it just takes 5-10) until the dead lights come back on!

Continuity/Voltage Detector

Each wall plug has a Hot, Neutral and Ground contact. Electricity is powered from the Hot contact and flows through the lights. It is similar to water flowing in a pipe. The LightKeeper Pro Continuity Detector/Voltage Detector uses an IC (Integrated Circuit) chip to find where the flow of electricity stops. It does this by detecting the minute electrical field emanating from the Hot wire even when a defect has caused the lights to go out. This electrical field when detected by the LightKeeper Pro, starts the beeping sound and continues as you scan the light string. When the electrical field stops emanating at the defect, the beeping stops. This shows where the problem is in miniature, series light strings. The detector finds the problem spot but the bulb or socket needs to be checked and appropriate repair action taken. The repair action may be securing a loose bulb, or testing a bulb to identify if it needs to be replaced.