Microjig GRR-RIPPER Advanced 3D Pushblock with Gravity Heel Kit Bundle

Microjig GRR-RIPPER Advanced 3D Pushblock

Unbelievable gripping power with Green-GRIP.

Green-GRIP is the proprietary non-slip material that gives you superior gripping power over workpieces and materials such as oak, cherry, walnut, ebony, pine, poplar, maple, plastics and aluminum. Treaded grooves provide increased traction on the workpiece even with sawdust. Easily cleaned with denatured or rubbing alcohol. No other push block’s grip comes close.

Precisely safe. Safely precise.

Precision, control and safety has never been so smart. The GRR-RIPPER acts as a Moving-Blade-Guard for total hand protection. The Adjustable Center Leg grips the off cut piece and prevents wood burn. The 1/4″ Leg controls the keeper piece. Balance Support stabilizes small and narrow workpieces. Fully adjustable to allow for a myriad of uses.

Versatility – Table Saws, Bandsaws, Router Tables, Jointers & More

Rip long stock on the table saw by using two GRR-RIPPERs with the hand-over-hand or leapfrog technique.

Flip the GRR-RIPPER for resawing and veneers

Use the GRR-RIPPER in the vertical position to resaw or veneer cuts firmly against the fence to prevent bandsaw drift and ensure a straight cut from beginning to end.

Safe and smart freehand and edge routing

Control your workpiece when freehand routing on your router table.

Extreme traction for face jointing

For proper and safe face jointing, you need technique, and reliable heavy-duty holding power. Strengthen your operation with our patented Green-GRIP non-slip material.

Microjig GRR-Ripper Gravity Heel Accessory Kit

The new Gravity Heel Kit for Micro Jig's GRR-Ripper (item: MJG-200) works so well you'd think it ran on batteries. This device allows a seamless transition for your GRR-Ripper from flat pushing block to a rear-pressure pushing stick when working at the table saw, router table, bandsaw or the jointer. The heel drops into place when you need it, then lifts away when you don't. Fully adjustable from 0-1-inch, this gravity operated heel accessory has been designed to double as a sacrificial component to your GRR-Ripper if you so need, so feel free to use it as a backing block when cutting end grain joints to prevent tear-out. The new Gravity Heel virtually eliminates tear-out and increases control and stability when feeding short or long stock on the table saw. It provides a secure backing on routing operations preventing blowout and can also be used as a template for repeat routing. The Gravity Heel is perfect for use with long stock on jointers. The Gravity Heel is there when you need it and gets out of the way when you don't.