MICROJIG Matchfit DVC-850AP 2-In1, Track And In-Line Dovetail Clamp (4 pack)

Microjig Matchfit DVC-850AP Strong, Large Versatile Track And In-Line Dovetail Clamp (Green)

The Microjig Matchfit Track and In-Line Dovetail Clamp are larger and more versatile. It allows more capacity for clamping larger items. It is perfect for clamping corners, dowels, and odd shapes. It is very strong and can clamp those tricky angles. Easily build additional jigs, sleds, fences, workbenches, and drill press tables by routing tracks with the MatchFit dovetail profile.

Anti-Pivot Coil Spring

The Anti-Pivot Coil Spring is designed to maintain the clamp arm’s height before inserting and after removing stock material. This allows you to quickly insert large stock or assemblies, and switch from part to part for repetitive processes—without having to reset the height of each clamp being used. The coil spring should be properly tensioned from the factory. However, you can adjust the coil spring tension by removing the screw at the top of the bar with a 4mm or 5/32 hex wrench (not included) and removing the clamp arm.

X-Pad

The X-pad is a removable upgrade that adds another level of functionality for a variety of clamping processes. It allows you to apply two directions of clamping pressure with just one clamp eliminating the need for two or more different clamps. To simultaneously apply vertical and in-line clamping pressure, position the X-Pad with the Pressure Transfer Notch at the top corner of your part, with the Edge Positioning Guide in line with the edge of the workpiece, as shown in. Tighten the clamp and ensure that the X-Pad pivots around the corner of the workpiece, with the rear-angled wall of the notch pushing against the vertical edge of the workpiece.